Features and Specifications of T Type Portable X-ray Flaw Detector with Ceramic X-Ray Tube
►Adopt the newest energy conversion, and rose to high-frequency operation, which make energy conversion rate improved by 30% compared with the traditional equipment, break through the traditional 1:1 working mode, no rest time requirement.
►Low heat, continuous working does not affect the service life.
►4000 turn all metal cooling fan make larger effective heat dissipation area; There will be no frequent over temperature protection during the full power continuous operation.
►Non flange design, small and beautiful apperance; End ring groove design make it easy to fix on the top of the pipe.
►Using high frequency paper film transformer, with strong heat resistance, low heat, High working efficiency and Low failure rate.
||160V – 255V 50 – 60HZ
|X – Ray Beam Cone Angle
|Controller Delaying Time
||0 – 1 min.
|Timing Range and Error
||9.9 min Minute Error ±1%
||Continuous Working; Exposure at any time; No mandatory rest
||Radiator forced air cooling
|Safety Working Pressure
||0.35 – 0.6 Mpa
|X-Ray Generator Weight(kg)
|Max. Penetration (mm)
|Working Conditions of X-ray Photography
||1. Focus to Film: 600mm
2. Exposure time: 5 min.
3. Film: TianJin, Model III, intensified by double lead foil.
4. Treatment in the darkroom: Temp. 20 ±2ºC, 5 min. blackness ≥ 1.5. sensitivity≤2%